Category Archives: Finger Joint Tray

Finger Joint Tray

G&G Tray in the Clamps

All clamped up with no where to go… I decided to go with walnut plugs instead of ebony to complement the lighter ash.  16 square plugs, each hand cut, pillowed, and polished.  I really need an intern. Advertisements

Posted in Finger Joint Tray | Tagged , | Leave a comment

Drilling Square Holes

Added a very unexciting bottom and drilled and chiseled 16 square peg holes. The holes are defined using a 3/8″ chisel off a mortising machine, drilled out with an undersized bit at the drill press, and pounded out with the … Continue reading

Posted in Finger Joint Tray | Tagged , | Leave a comment

Finger Joints To Be Proud Of

This evening, I started work on a simple tray with proud finger joints. I’m not sure where the project is going; I mostly wanted to give proud finger joints a try. So far so good. All the joints are hand-cut … Continue reading

Posted in Finger Joint Tray | Tagged , | Leave a comment